Pianos routinely make movers yearly list of items that are most frequently damaged. Grand pianos are especially bothersome. Practicing the following procedures for dismantling, padding and filling grand pianos will prevent damage, lower claims cost, and improve consumer complete satisfaction.
1) A minimum of three individuals are needed to handle an infant grand piano. If the baby grand piano requires to increase or down stairs or if a full or show grand piano requires to be carried, a minimum of four individuals are required.
2) Always complete a extensive and precise stock. It might be more effective or needed to utilize a visual stock to properly describe and show pre-existing damage.
3) As different parts are dismantled, please place all hardware in an effectively labeled parts bag and then place the parts bag in a "Components Box".
4) Get rid of the music rack (lyre) from its track by pulling it towards the keyboard. Wrap it in a clean furniture pad.
5) Disconnect the lid by eliminating the hinge pins. Have one individual wiggle the lid, holding it opposite the hinge, while a second person works the pin loose. Please take care not to harm the wood with the pliers or with the pin itself. Cover the jaws of the pliers with a little fabric to help prevent damage to the wood if essential. Wrap the cover in a tidy furniture pad.
6) Remove the prop that holds the cover open and cover it in a clean furnishings pad. The prop has a hinge pin and remains in 2 pieces.
7) Remove the pedal assembly and cover it in a clean furniture pad. The braces at the back of the assembly rest in slots at each end. When removing the screws, please beware not to drop the braces. In addition, please be specifically careful with the push-rods so that they will not get bent. As you deal with the piano, number the push-rods from left to right as "1", "2", and "3", by placing a piece of masking tape with the suitable number on each rod. Note: If masking tape is not available, please use properly labeled parts bags for this purpose. When reassembling at location, please be sure to put the rods in the proper order so that the pedals will work appropriately.
8) Pad the piano by putting a tidy rolled furniture pad (stretch-wrap the pad to prevent it from unrolling) on the cover of the keyboard to prevent it from flopping open while you deal with the piano. Note: Please ensure that the surface area of the piano is dust-free prior to padding it.
9) Position a piano board and connect the straps so that it is prepared to get the piano. The raised brace on the piano board ought to be at the keyboard end of the piano.
10) Eliminate the left front leg by positioning one person below the piano at the left end of the keyboard. The other 2 individuals ought to support the left front corner. The person below the piano need to turn the keeping block so that the long end points away from the leg. The screws, if there are any, should then be removed. The "below" person should then extricate the piano before in fact eliminating the leg. Be sure to have two individuals lifting the corner of the piano while the third individual removes the leg. Keep in mind: Please be sure to keep in mind which legs were gotten rid of from which positions considering that some pianos have legs that are not interchangeable.
11) Place the piano on the piano board by lowering the "leg-less" end onto the board. Please be sure to lift the whole piano slightly while finishing this maneuver to avoid excessive pressure on the staying, connected legs as the piano ideas. Be sure that the piano is focused snugly versus the brace at the end of the piano board.
12) Get rid of the 2 staying legs and wrap them in clean furnishings pads. These legs are kept in place by a "key and slot" plan. To remove the leg, slide it inward toward the center of the piano till it comes out of the slot.
13) Protect the piano to the piano board by bringing the ends of the straps together and fastening them. Location folded burlap pads over the furnishings pads but under the straps to supply extra defense to the edges of the piano. To prevent the strap near the narrow end of the piano from slipping off, tie the loose ends of the 2 straps together.
14) To move the piano over a flat, level surface, tilt the piano and piano board and location a four-wheel dolly under the center of the piano board.
15) To move the piano up or down stairs, check here use the piano board as a skid. After adequately padding the stairs for security against home damage, put the keyboard end of the piano toward the bottom of the stairs. Connect a hump strap to the leading end of the piano board to prevent the piano from slipping.
16) To pack the piano, leave it on the piano board and location it in a tier as the first base product with the keyboard facing the wall of the preceding tier. The best location to load the padded cover is between the piano and the preceding tier or in between the wall and the piano.
Although grand pianos represent a substantial challenge, they can be moved without damage by using sound judgment and practicing the treatments listed above.